genie garage door opener keypad programming

Take out the light cover of the device installed inside the garage door by unscrewing it using ladder.So Here Are Steps To Follow Of How To Reprogram Genie Garage Door Keypad Note that after you open or close the door with the keypad, you can cause the door to stop and reverse by pressing any button while the doors still in motion. When you put in the code and press the up/down button, the garage door will open. Press the up/down button for a third time.Enter your pin, then press the up/down button.The long LED light will begin to flash purple. The round LED light will turn blue and then turn off. Enter a pin that is three to eight numbers in length.Enter, in order, 3-5-7, then press the PRGM/SET button.Press and hold the PRGM/SET button until the small, round LED light starts flashing red.Enter, in order, the numbers 3-5-7, then press the large up/down button.Connect the keypad to the Genie opener:.To program your Genie keypad, follow these three steps: Refer to the keypad owners manual for instructions. If youre linking the keypad to more than one garage door, the process will be different. These instructions are for linking a Genie keypad with a Genie opener for a single garage door.

Genie Intellicode Wireless Keypad Programming & Installations Instructions

Genie garage door opener keypad programming